78M6618-IMR View Datasheet(PDF) - Teridian Semiconductor Corporation

Part Name

Description

Manufacturer

78M6618-IMR

Octal Power and Energy Measurement IC

Teridian Semiconductor Corporation 

DS_6618_005

78M6618 Data Sheet

1.20 UARTs

The 78M6618 includes two UARTs (UART0 and UART1) that can be programmed to communicate with a

variety of external devices. The UARTs are dedicated 2-wire serial interfaces, which can communicate at

rates up to 38,400 bits/s. All UART transfers are programmable for parity enable, parity, 2 stop bits/1

stop bit and XON/XOFF options for variable communication baud rates from 300 to 38,400 bps. See the

78M6618 Programmer’s Reference Manual for more information regarding the use of the UART

resources.

1.20.1 UART1 (OPT_TX/OPT_RX)

The device includes an interface to implement an IR/optical port on UART1. The pin OPT_TX is

designed to directly drive an external LED for transmitting data on an optical link. The pin OPT_RX has

the same threshold as the RX(UART0) pin, but can also be used to sense the input from an external

photo detector used as the receiver for the optical link. Alternately, the UART1 may be interfaced with a

standard level UART transceiver. Contact Teridian support for more information.

1.21 In Circuit Emulator (ICE) Port

The 78M6618 implements an In Circuit Emulator(ICE) port for debug and programming of the device. To

enable the use of the port the ICE_E pin must be pulled high. In this mode the SEG11,SEG10 and SEG9

pins are repurposed and the E_RST, E_TCLK and E_RXTX pins respectively. Please contact Teridian

support for more information regarding the use of the ICE interface for device programming and debug.

Rev. 1.4

13

Share Link: