5-104652-6 View Datasheet(PDF) - Tyco Electronics

Part Name

Description

Manufacturer

5-104652-6

Ribbon Cable Interconnect Solutions

Tyco Electronics 

Ribbon Cable Interconnect Solutions

Universal Ejection Style Pinless Headers, Military, Center

and Dual Polarized, .100 x .100 [2.54 x 2.54] Centerlines (Continued)

Installation of Press-Fit

Pinless Headers

Insertion Instructions:

1. Place pinless header

over preinstalled posts

so that post tips start into

header cavities.

2. With bottom of pc board

supported, place steel

block over header. Steel

block must be wider and

longer than header so

that it covers all four sides

of the header. However,

for headers with latches

pre-assembled, the steel

block must not interfere

with the latches.

3. Apply an even, centered

force on steel block until

header bottoms on pc

board. If posts are longer

than .545 [13.84], they

may be forced against

the steel block before the

header is fully seated. In

this situation, extreme

caution must be taken so

that posts are not dam-

aged or pushed out of

the pc board.

FORCE

Steel Block

(Centered over

Header)

Pinless Header

.025 Sq. Posts

[0.64]

Preinstalled in

PC Board

PC Board

Insertion Force: 60 lb. [267 N] max.

Retention Force: 20 lb. [89 N] min.

TE recommends the use of a typical manual frame assembly for insertion of

pinless headers. The frame assembly and steel block are not supplied by TE.

FORCE

.529

[13.44]

Catalog 82012

Revised 4-12

www.te.com

Dimensions are shown for

reference purposes only.

Specifications subject

to change.

Dimensions are in inches

and millimeters unless

otherwise specified.

USA: +1 (800) 522-6752

Canada: +1 (905) 475-6222

Mexico/C. Am.: +52 (0) 55-1106-0800

Latin/S. Am.: +54 (0) 11-4733-2200

Germany: +49 (0) 6251-133-1999

93

UK: +44 (0) 800-267666

France: +33 (0) 1-3420-8686

Netherlands: +31 (0) 73-6246-999

China: +86 (0) 400-820-6015

Share Link: