5962-8764802XA View Datasheet(PDF) - Austin Semiconductor
Part Name
Description
Manufacturer
5962-8764802XA Datasheet PDF : 11 Pages
| |||
Austin Semiconductor, Inc.
UVEPROM
SMJ27C512
ABSOLUTE MAXIMUM RATINGS*
Supply Voltage Range, VCC**...........................-0.6V to +7.0V
Supply Voltage Range, Vpp**.........................-0.6V to +14.0V
Input Voltage Range, All inputs except A9**....-0.6V to 6.5V
A9....-0.6V to +13.5V
Output Voltage Range**...............................-0.6V to VCC +1V
Operating Cage Temperature Range, TC.........-55°C to 125°C
Storage Temperature Range, Tstg.....................-65°C to 150°C
*Stresses greater than those listed under "Absolute Maximum
Ratings" may cause permanent damage to the device. This is
a stress rating only and functional operation of the device at
these or any other conditions above those indicated in the
operation section of this specification is not implied.
Exposure to absolute maximum rating conditions for extended
periods may affect reliability.
** All voltage values are with respect to GND.
RECOMMENDED OPERATING CONDITIONS
VCC
G\ /VPP
VID
VIH
VIL
TC
Supply Voltage1
Supply Voltage2
Read Mode
SNAP! Pulse programming algorithm
SNAP! Pulse programming algorithm
Voltage level on A9 for signature mode
High-level DC input voltage
Low-level DC input voltage
Operating case temperature
TTL
CMOS
TTL
CMOS
MIN
4.5
6.25
12.75
11.5
2
VCC-0.2
-0.5
-0.5
-55
NOM
5
6.5
13
MAX
5.5
6.75
13.25
12.5
VCC+1
VCC+1
0.8
0.2
125
UNIT
V
V
V
V
V
V
V
V
°C
NOTES:
1. VCC must be applied before or at the same time as G\ /VPP and removed after or at the same time as G\ /VPP. The deivce must not be inserted into or removed
from the board when G\ /VPP or VCC is applied.
2. G\ /VPP can be connected to VCC directly (except in the program mode). VCC supply current in this case is ICC + IPP.
ELECTRICAL CHARACTERISTICS OVER RECOMMENDED RANGES OF
OPERATING CONDITIONS
PARAMETER
TEST CONDITIONS
MIN
VOH High-level output voltage
IOH = -400µA
2.4
VOL Low-level output voltage
IOL = 2.1mA
II Input current (leakage)
VI = 0V to 5.5V
IO Output current (leakage)
IPP G\ /VPP supply current (during program pulse)2
VO = 0V to VCC
G\ /VPP = 13V
TTL-Input Level
ICC1 VCC supply current (standby)
VCC = 5.5V, E\=VIH
CMOS-Input Level VCC = 5.5V, E\=VCC
ICC2 VCC supply current (active)
E\=VIL, VCC=5.5V
tcycle = minimum cycle time,
outputs open
NOTES:
1. Typical values are at TC=25°C and nominal voltages.
2. This parameter has been characterized at 25°C and is not production tested.
TYP1
35
35
MAX
0.4
10
10
70
500
325
50
SMJ27512
Rev. 1.0 9/01
Austin Semiconductor, Inc. reserves the right to change products or specifications without notice.
5
|
|
Share Link: 