DatasheetQ Logo
Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

I1817A-08QR View Datasheet(PDF) - PulseCore Semiconductor

Part Name
Description
Manufacturer
I1817A-08QR
PULSECORE
PulseCore Semiconductor PULSECORE
I1817A-08QR Datasheet PDF : 10 Pages
1 2 3 4 5 6 7 8 9 10
February 2007
rev 1.1
P1817A/B
Low-Power Mobile VGA EMI Reduction IC
Features
FCC approved method of EMI attenuation.
Generates a low EMI spread spectrum clock of the
input frequency.
Optimized for frequency range from 60 to 175MHz.
Internal loop filter minimizes external components
and board space.
Four selectable spread ranges.
Low inherent cycle-to-cycle jitter.
3.3V operating voltage range.
TTL or CMOS compatible inputs and outputs.
Ultra-low power CMOS design.
3.17mA @3.3V, 10MHz | 6.20mA @5.0V, 10MHz
4.28mA @3.3V, 14MHz | 7.50mA @5.0V, 14MHz
5.50mA @3.3V, 20MHz | 9.50mA @5.0V, 20MHz
Supports notebook VGA and other LCD timing
controller applications.
SSON/SBM pin for Spread Spectrum On/Off
and Standby Mode controls.
Available in 8-pin SOIC and TSSOP.
Product Description
The P1817 is a versatile spread spectrum frequency
modulator designed specifically for input clock frequencies.
The P1817 reduces electromagnetic interference (EMI) at
the clock source, allowing system wide reduction of EMI of
down stream clock and data dependent signals. The P1817
allows significant system cost savings by reducing the
number of circuit board layers ferrite beads, shielding and
other passive components that are traditionally required to
pass EMI regulations.
The P1817 modulates the output of a single PLL in order to
“spread” the bandwidth of a synthesized clock, and more
importantly, decreases the peak amplitudes of its
harmonics. This results in significantly lower system EMI
compared to the typical narrow band signal produced by
oscillators and most frequency generators. Lowering EMI
by increasing a signal’s bandwidth is called ‘spread
spectrum clock generation’.
The P1817 uses the most efficient and optimized
modulation profile approved by the FCC and is
implemented in a proprietary all digital method.
Applications
The P1817 is targeted towards notebook LCD displays,
and other displays using an LVDS interface, PC peripheral
devices, and embedded systems.
Block Diagram
SR0
SSON
VDD
CLKXIN
REF
Frequency
Divider
Feedback
Divider
Modulation
Phase
Detector
Loop
Filter
PLL
VCO
Output
Divider
ModOUT
VSS
PulseCore Semiconductor Corporation
1715 S. Bascom Ave Suite 200, Campbell, CA 95008 Tel: 408-879-9077 Fax: 408-879-9018
www.pulsecoresemi.com
Notice: The information in this document is subject to change without notice.
 

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]