ADSP-2104KP-80 View Datasheet(PDF) - Analog Devices

Part Name

Description

Manufacturer

ADSP-2104KP-80

Low Cost DSP Microcomputers

Analog Devices 

ADSP-2104/ADSP-2109

SPECIFICATIONS (ADSP-2104L/ADSP-2109L)

TEST CONDITIONS

Figure 16 shows voltage reference levels for ac measurements.

VDD

INPUT

2

VDD

OUTPUT

2

Figure 16. Voltage Reference Levels for AC Measurements

(Except Output Enable/Disable)

Output Disable Time

Output pins are considered to be disabled when they have

stopped driving and started a transition from the measured

output high or low voltage to a high impedance state. The

output disable time (tDIS) is the difference of tMEASURED and

tDECAY, as shown in Figure 17. The time tMEASURED is the

interval from when a reference signal reaches a high or low

voltage level to when the output voltages have changed by 0.5 V

from the measured output high or low voltage.

The decay time, tDECAY, is dependent on the capacitative load,

CL, and the current load, iL, on the output pin. It can be

approximated by the following equation:

from which

tDECAY

=

CL × 0.5 V

iL

tDIS = tMEASURED – tDECAY

is calculated. If multiple pins (such as the data bus) are dis-

abled, the measurement value is that of the last pin to stop

driving.

Output Enable Time

Output pins are considered to be enabled when they have made

a transition from a high-impedance state to when they start

driving. The output enable time (t ENA) is the interval from

when a reference signal reaches a high or low voltage level to

when the output has reached a specified high or low trip point,

as shown in Figure 17. If multiple pins (such as the data bus)

are enabled, the measurement value is that of the first pin to

start driving.

REFERENCE

SIGNAL

tMEASURED

tDIS

VOH (MEASURED)

VOL (MEASURED)

OUTPUT

tDECAY

VOH (MEASURED) – 0.5V

VOL (MEASURED) +0.5V

tENA

2.0V

1.0V

OUTPUT STOPS

DRIVING

OUTPUT STARTS

DRIVING

HIGH-IMPEDANCE STATE.

TEST CONDITIONS CAUSE

THIS VOLTAGE LEVEL TO BE

APPROXIMATELY 1.5V.

VOH (MEASURED)

VOL (MEASURED)

Figure 17. Output Enable/Disable

IOL

REV. 0

TO

OUTPUT

VDD

PIN

2

50pF

IOH

Figure 18. Equivalent Device Loading for AC Measurements

(Except Output Enable/Disable)

–19–

Share Link: