|Description||5-A Low Dropout Positive Regulators|
|LM1084IT-5.0 Datasheet PDF : 29 Pages |
SNVS037G – SEPTEMBER 1999 – REVISED JANUARY 2015
Feature Description (continued)
However, the adjustable version allows this degradation of ripple rejection to be compensated. The adjust
terminal can be bypassed to ground with a capacitor (CADJ). The impedance of the CADJ should be equal to or
less than R1 at the desired ripple frequency. This bypass capacitor prevents ripple from being amplified as the
output voltage is increased.
1/(2π × fRIPPLE*CADJ) ≤ R1
7.3.2 Load Regulation
The LM1084 regulates the voltage that appears between its output and ground pins, or between its output and
adjust pins. In some cases, line resistances can introduce errors to the voltage across the load. To obtain the
best load regulation, a few precautions are needed.
Figure 12 shows a typical application using a fixed output regulator. Rt1 and Rt2 are the line resistances. VLOAD
is less than the VOUT by the sum of the voltage drops along the line resistances. In this case, the load regulation
seen at the RLOAD would be degraded from the data sheet specification. To improve this, the load should be tied
directly to the output pin on the positive side and directly tied to the ground pin on the negative side.
Figure 12. Typical Application Using Fixed Output Regulator
When the adjustable regulator is used (Figure 13), the best performance is obtained with the positive side of the
resistor R1 tied directly to the output pin of the regulator rather than near the load. This eliminates line drops
from appearing effectively in series with the reference and degrading regulation. For example, a 5-V regulator
with 0.05Ω resistance between the regulator and load will have a load regulation due to line resistance of 0.05Ω
× IL. If R1 (= 125Ω) is connected near the load the effective line resistance will be 0.05Ω (1 + R2/R1) or in this
case, it is 4 times worse. In addition, the ground side of the resistor R2 can be returned near the ground of the
load to provide remote ground sensing and improve load regulation.
Figure 13. Best Load Regulation Using Adjustable Output Regulator
Submit Documentation Feedback
Product Folder Links: LM1084
Copyright © 1999–2015, Texas Instruments Incorporated
|Direct download click here|
|Share Link :|