ST6200C ST6201C ST6203C
8.3 A/D CONVERTER (ADC)
The on-chip Analog to Digital Converter (ADC) pe-
ripheral is a 8-bit, successive approximation con-
verter. This peripheral has multiplexed analog in-
put channels (refer to device pin out description)
that allow the peripheral to convert the analog volt-
age levels from different sources.
The result of the conversion is stored in a 8-bit
Data Register. The A/D converter is controlled
through a Control Register.
Figure 28. ADC Block Diagram
8.3.2 Main Features
■ 8-bit conversion
■ Multiplexed analog input channels
■ Linear successive approximation
■ Data register (DR) which contains the results
■ End of Conversion flag
■ On/Off bit (to reduce consumption)
■ Typical conversion time 70 µs (with an 8 MHz
The block diagram is shown in Figure 28.
ANALOG TO DIGITAL
ADR7 ADR6 ADR5 ADR4 ADR3 ADR2 ADR1 ADR0
Note: ADC not present on some devices. See device summary on page 1.
Doc ID 4563 Rev 5