AH101J View Datasheet(PDF) - Unspecified
Part Name
Description
Manufacturer
AH101J Datasheet PDF : 18 Pages
| |||
SAFETY STANDARDS REGULATED, REINFORCED
INSULATION TYPE, AH SERIES
POE-D10-00-E-13
Ver: 13 Page: 11 / 18
No
7.3.9
Items
Performance
Testing method
Tensile
Lead wire shall not cut off.
Capacitor shall not be
broken.
With the termination in its normal position, the specimen is
held by its body in such a manner that the axis of the
termination is vertical; the tensile force of 10N shall be
applied to the termination in the direction of its axis and
acting in a direction away from the body of the specimen.
Robustness
of
Terminations
Bending
Lead wire shall not cut off.
Capacitor shall not be
broken.
With the termination in its normal position, the specimen is
held by its body in such a manner that the axis of the
termination is vertical; a mass applying a force of 5N is then
suspended from the end of the termination. The body of the
specimen is then inclined, within a period of 2 to 3sec,
through an angle of approximately 90∘in the vertical plane
and then returned to its initial position over the same period
of time; this operation constitutes one bend. One bend
immediately followed by a second bend in the opposite
direction.
Appearance No marked defect.
I.R. 1000 MΩ min.
As shown in figure, the lead wires should be immersed in
solder of 350 ± 10 ℃ or 260 ± 5 ℃ up to 1.5 to 2.0 mm from
the root of terminal for 3.5 ± 0.5 sec ( 10 ± 1 sec. for 260 ± 5
℃ ).
Dielectric
Strength
Per item7.3. 3
7.3.10
Soldering
Effect
(Non-Preheat)
Y5P,Y5U,Y5V：
Within ±10 %
Pre-treatment:
Capacitance SL,CH:
Within±2.5﹪or
Capacitor shall be stored at 85±2℃ for 1hour.then placed
at ※1room condition for 24±2hours before initial
measurements.
±0.25pF,Whichever is large.
Post-treatment:
Capacitor shall be stored for 1 to 2hours at ※1room
condition.
Appearance No marked defect.
First the capacitor should be stored at 120+0/-5 ℃ for 60
+0/-5 sec.
Then , as in figure , the lead wires should be immersed solder
of 260+0/-5 ℃ up to 1.5 to 2.0 mm from the root of terminal
for 7.5+0/-1 sec.
7.3.11
Soldering
Effect
(On-Preheat)
I.R. 1000 MΩ min.
Dielectric
Strength
Per item 7.3.3
Pre-treatment:
Y5P,Y5U,Y5V：
Within ±10 %
Capacitor shall be stored at 85±2℃ for 1hour.then placed
at ※1room condition for 24±2hours before initial
measurements.
Capacitance SL,CH:
Within±2.5﹪or
±0.25pF,Whichever
is
large.
Post-treatment:
Capacitor shall
condition.
be
stored
for
1
to
2hours
at
※1room
|
|
Share Link: 