AD7853LAR View Datasheet(PDF) - Analog Devices

Part Name

Description

Manufacturer

AD7853LAR

3 V to 5 V Single Supply, 200 kSPS 12-Bit Sampling ADCs

Analog Devices 

AD7853/AD7853L

CONTROL REGISTER

The arrangement of the control register is shown below. The control register is a write only register and contains 14 bits of data. The

control register is selected by putting two 1s in ADDR1 and ADDR0. The function of the bits in the control register are described

below. The power-up status of all bits is 0.

MSB

ZERO

ZERO

ZERO

ZERO

PMGT1 PMGT0 RDSLT1

RDSLT0 2/3 MODE CONVST CALMD

CALSLT1 CALSLT0

STCAL

LSB

Control Register Bit Function Descriptions

Bit

Mnemonic

Comment

13

ZERO

12

ZERO

11

ZERO

10

ZERO

These four bits must be set to 0 when writing to the control register.

9

PMGT1

8

PMGT0

Power Management Bits. These two bits are used with the SLEEP pin for putting the part into various

power-down modes (See Power-Down section for more details).

7

RDSLT1

6

RDSLT0

These two bits determine which register is addressed for the read operations. See Table II.

5

2/3 MODE

Interface Mode Select Bit. With this bit set to 0, Interface Mode 2 is enabled. With this bit set to 1,

Interface Mode 1 is enabled where DIN is used as an output as well as an input. This bit is set to 0 by

default after every read cycle; thus when using Interface Mode 1, this bit needs to be set to 1 in every

write cycle.

4

CONVST

Conversion Start Bit. A logic one in this bit position starts a single conversion, and this bit is automati-

cally reset to 0 at the end of conversion. This bit may also used in conjunction with system calibration

(see Calibration Section on page 21).

3

CALMD

Calibration Mode Bit. A 0 here selects self-calibration and a 1 selects a system calibration (see Table III).

2

CALSLT1

Calibration Selection Bits and Start Calibration Bit. These bits have two functions.

1

CALSLT0

With the STCAL bit set to 1, the CALSLT1 and CALSLT0 bits determine the type of calibration per-

0

STCAL

formed by the part (see Table III). The STCAL bit is automatically reset to 0 at the end of calibration.

With the STCAL bit set to 0, the CALSLT1 and CALSLT0 bits are decoded to address the calibration

register for read/write of calibration coefficients (see section on the calibration registers for more details).

Table III. Calibration Selection

CALMD

0

0

0

0

1

1

1

1

CALSLT1

0

0

1

1

0

0

1

1

CALSLT0

0

1

0

1

0

1

0

1

Calibration Type

A full internal calibration is initiated where the internal DAC is calibrated followed by the

internal gain error and finally the internal offset error is calibrated out. This is the default setting.

Here the internal gain error is calibrated out followed by the internal offset error calibrated

out.

This calibrates out the internal offset error only.

This calibrates out the internal gain error only.

A full system calibration is initiated here where first the internal DAC is calibrated, fol-

lowed by the system gain error, and finally the system offset error is calibrated out.

Here the system gain error is calibrated out followed by the system offset error.

This calibrates out the system offset error only.

This calibrates out the system gain error only.

–10–

REV. B

Share Link: